Shimadzu ELB600 Manuel d'instructions télécharger pdf (Page 14)

4. Cautions and Notices

Observe the

following:

CAUTION! Use only the AC adaptor provided by the distributor authorized

by Shimadzu if using an AC adaptor.

NOTICE Make sure that any foreign objects, including water and metal

pieces, do not enter the interior of the balance.

NOTICE Do not leave the balance with objects on the pan.

NOTICE Do not cause a shock to the pan.

5. Measurement Procedure

The procedures are explained using the ELB300 as an example.

Turn on the power

(1)

(2)

(3)

(4)

(5)

(6)

Check that nothing is placed on the pan.

Press the [ON/OFF(BREAK)] key.

The Check display will illuminate, indicating

that the temperature sensor inside the

balance is being checked.

Depending on the ambient temperature, this

may remain illuminating for about 30 seconds.

The all segments illuminate for approximately

6 seconds.

Zero is displayed.

The zero may be unstable immediately after

the power is turned on. Allow the balance to

warm up for more than 5 minutes. To conduct

accurate measurements, a warm up time of

over 30 minutes is recommended.

Calibrate sensitivity (refer to “9. Calibration”).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Pas de commentaire

Shimadzu ELB600 Manuel d'instructions Page 14